Owatrol Dilunett
















π₯ Hot
















Owatrol Dilunett}
from
17.81β¬
Ex Tax: 14.48β¬
Available Options
Safely and Easily Remove Paint with Solvent Free Paint Remover with Owatrol Dilunett
Solvent Free Paint Remover, Paint Stripper Safe For All Surfaces.
Solvent free paint remover, paint stripper β strips up to 8 coats at one application removing paint, wax and varnish
- Simple water rinse off.
- Easy to apply gel consistency doers not run β ideal for vertical surfaces
- Does not dry β long active working time (up to 12 hours)
- Removes up to 8 coats of paint, varnish, stains and most anti-fouling paints
- Strips ornate or intricate surfaces fast and easy
Properties
- Does not contain solvent or paraffin β non flammable.
- Strips waxes, varnish, paint and most antifouling paints.
- Coating becomes soluble with water (rinse with water).
- Strips up to 8 coats of paint in 1 application.
- Easy to apply, even on the most difficult or intricate surfaces
- Does not evaporate β will not dry.
- Softens the paint layers without supervision.
Where to use
- Use on wood (Except Oak, Chestnut, Parquet and Veneer), metals (except Aluminum), plastic, stone, cement β¦
- Ideal for difficult to strip surfaces such as ornate, horizontal and vertical β doors, gates, stone etc.
- Recommended for stripping large areas β non-flammable, does not dry out, remains active a long time.
- Does not attack plastics, rubber, synthetic coating or fibreglass gel coats (GRP boats etc).
Safely and Easily Remove Paint with Solvent Free Paint Remover with Owatrol Dilunett
Safely and Easily Remove Paint with Solvent Free Paint Remover with Owatrol Dilunett
Recommendations for use
- Always test a small area first.
- Wear protective gloves β rubber, nitrile. Use nylon/synthetic brushes.
- Working time for stripping the finish varies from minutes to hours depending on the type of finish being removed (oil-based or water-based) and number of coats. Check the stripping action from time to time to establish when full removal of the finish(s) can be performed.
- Always neutralise surface with Net-trol (diluted 4:1) after stripping.
Directions for use
- Apply a thick layer of Dilunett to surface to be stripped.
- Allow to stand.
- If the Dilunett paint remover starts to dry, apply a fine mist of water to keep active.
- Scrub surface with stiff nylon brush and rinse with water using the highest pressure source available or use a pressure washer (max. 60 bar / 870 psi & not too close to the wood).
- Using hot water makes stripping the paint easier.
- After stripping wood, always neutralise with Net-trol, diluted 4:1 with water immediately after rinsing the Dilunett.
- Refer to packaging for full instructions.
Coverage : 4 mΒ²/l
Application tools : Brush - Stiff bristle
Application temperature : 5Β°C to +35Β°C
Working time : 5 min. to 12 h.
Clean-up : Water



















